100% secure shopping!
Your data are safe with us. SSL-Protected!
The new programmable series »E/PSB 10000-4U« of EPS Electronic Power Supply is a bidirectional power supply that meets multiple requirements and solves multiple tasks.
First and foremost, the system is a power supply. It also meets the function of an electronic load by absorbing energy and feeding it back into the grid. The parameters for the power supply as well as for those for the electronic load can be adjusted flexibly. The integrated functions include a battery test mode, a arbitrary generator and a vehicle start-up curve. As the internal resistance is adjustable, the functioning of batteries, fuel cells or photovoltaic modules can also be reproduced. The power supply E/PSB can also be used to return the energy in test processes, for example on a drive test rig, to the supply source.
The following simulations are available: Battery (SOC), LV123/LV124LV148 (DIN 40839), PV (EN50530) and FC.
The bidirectional power supplies are modular. They enable services up to 30kW with a flexible output stage, for example from 500V and +-180A in a 19inch, 4U housing. The spectrum of devices ranges from a output voltage from 60 to 2000V to in-/output currents from +-40 to 1000A. It is also possible to combine up to 32 devices in a single network to build up up to 1,08MW. The change between source and sink operation is seamless and continuous. This means there is no dwell time, and it is still too short, at zero crossing.
All models are microprocessor controlled. This allows accurate and fast measurement of actual values.
Nominal and actual values, status indicators and messages are displayed clearly on an intuitive TFT touch panel.
For remote control using a PC or PLC the devices are provided as standard with a USB-B slot on the rear side as well as a galvanically isolated analog interface. Via optional plug-in interface modules, other digital interfaces such as Profibus, ProfiNet, ModBus, CANopen, a GPIB interface and more can be added.These enable the devices to be connected to standard industrial buses simply by changing or adding a small module. The configuration, if necessary at all, is simple. Thus the power supplies may, for example, be operated with other power supplies or even other types of equipment or controlled by a PC or PCL, all using the digital interfaces.
Further options are extended warranty and calibration with protocol.
Energy efficiency: Energy recovery, high efficiency, temperature controlled fans
Scope of delivery:
Power Supply Unit
Test report
AC-plug 5 pole
Share bus plug
Remote Sensing plug
1,8m USB cable
Set of DC-terminal cover
Set for strain relief
USB-Stick with manual and Software
| Show 1 to 4 (of in total 9 products) | Sites: 1 2 3 [next >>] |
